Builder
Joined: 03 Sep 2017 Posts: 32 Location: Indiana
|
Link Posted: Fri Jan 25, 2019 9:30 pm Post subject: Drew a schematic |
|
|
I tried drawing this by hand with a pencil, but kinda ran out of room, so I drew it on autocad. I have to figure out how to make a dot and show which wires are tied together and which aren't.
White is neutral, yellow is the regular 120 volt, (except for the element on lights) and purple is the small gauge signal wire.
I still have to add the volt and amp gauges, and I left off the interlock stuff because it has normally closed switches stacked on top of normally open switches. (And it's not required)
If someone wants to look this over and double check, and it's ok, I'll work on the other half with the relays and such.
How can I export this in a format that doesnt require autocad?
|
|