bhizzy1
Joined: 30 Aug 2018 Posts: 1 Location: Pittsburgh, PA, USA
|
Link Posted: Mon Jan 21, 2019 3:04 pm Post subject: Auber Instruments JSL-71A Timer Wiring |
|
|
I just finished up my panel wiring and I wanted to share the wiring I used for the JSL-71A Easy Timer from Auber Instruments. I had some trouble as I was missing a jumper. I don't have a diagram but hopefully this write up will help someone else wire it up quickly and without issues.
Pin 1 - Connects to reset button on the same side as the connection routing to neutral bus, Jumper to Pin 10
Pin 2
Pin 3
Pin 4
Pin 5 - Connects to the reset button on the side opposite the connection routing to neutral bus.
Pin 6 -
Pin 7 - To timer on/off switch
Pin 8 - Jumper to Pin 9
Pin 9 - Jumper to Pin 8 and to pin 13 on the HLT PID
Pin 10 - Jumper to Pin 1
This pin assignment is based on the newer model with serial number no beginning with 12.
I'll try to draw up a diagram and post it at some point.
|
|