Lengthening rtd probe leads?

JoeBrewer · Joined: 31 Dec 2011 Posts: 2 Location: Olympia, WA

I'm converting my B3 1550 system to electric. The location of the panel from the brew system requires a little longer leads on the temp probes. Is there anything I need to be concerned about with the type of conductor? I was planning on soldering stranded copper 22 gauge leads onto the ones already connected to the probes I got from Auber.

Thanks,
Joe

**kal** · Posted: Mon Jan 16, 2012 8:32 pm Post subject:

I would use the same type of wire:

http://www.auberins.com/index.php?main_page=product_info&cPath=20_15&products_id=213

That's what we use when we sell probes that require longer cables.

Kal

JoeBrewer · Joined: 31 Dec 2011 Posts: 2 Location: Olympia, WA

That's perfect! Thanks for the link.

**kal** · Posted: Mon Jan 16, 2012 9:28 pm Post subject:

No problems. If you'd rather purchase all the parts from us or purchase it already pre-built and tested, drop us an email at sales@TheElectricBrewery.com.

Kal

kkroeker · Joined: 08 Sep 2015 Posts: 19 Location: Oklahoma

I know this is an old thread. I was wondering if you could just buy the wire on the link to make some pigtails with a set of xlr's?

I'm a bit short on my lengths in my new location. I don't want to have to build a whole new cable, I would prefer to build just a patch.

**kal** · Posted: Mon Feb 15, 2016 2:07 pm Post subject:

Sure - that will work.

Kal