Vinyl Gas line

[DFB]

Register to remove this ad. It's free!

All
With my first brew under my belt on the system (I'll post that soon), I'm working on putting together the dispensing system.

I bought this for the gas hose to run my CO2 primary to secondary & secondary to kegs. I also was going to use the same from my nitro beer gas primary to a keg.

https://www.micromatic.com/5-16-inch-id/5-16-inch-id-blue-vinyl-gas-hose-50-feet-coil-553b600?affId=70238

Upon closer reading the specs says "vinyl hose is used in low—pressure applications under 50 PSI"

While I'd never dispense beer above 50 PSI, the gauges do go to 60 PSI.

Welcome thoughts. Thanks

[kal]

I wouldn't have any issues using that gas line for standard serving. That's what it's meant for.

If you're looking for more info on what I did with my tap lines, check out my basement build thread: http://www.theelectricbrewery.com/forum/viewtopic.php?t=25593

(There are a few links in the first post to how the bar/draft equipment is all hooked up and what I use).

Have fun!

Kal

[kal]

I wouldn't have any issues using that gas line for standard serving. That's what it's meant for.

If you're looking for more info on what I did with my tap lines, check out my basement build thread: http://www.theelectricbrewery.com/forum/viewtopic.php?t=25593

(There are a few links in the first post to how the bar/draft equipment is all hooked up and what I use).

Have fun!

Kal