Volt and Amp Meter wiring

[BrewCrew]

Register to remove this ad. It's free!

Hello,

Been searching thru the forum on how to wire up the volt meter ....cant really tell what pole is what but assuming the writing on the top left is a legend I assume the red wire would be the 5V+ and the black is the 5V-grd. is this correct??



thank You

Jason

[kal]

Hi Jason,

Wiring instructions are included on the page where you ordered. See: https://shop.theelectricbrewery.com/collections/power-supplies/products/3-digit-blue-led-digital-panel-volt-meter-700v-ac-5v-dc-supply

The "volt and amp meter wiring instructions" section of our control panel build instructions also goes into further detail: http://www.theelectricbrewery.com/control-panel-part-2?page=9

You've got the red and black wires connected to the AC (signal) inputs and no the +5VDC and DC GND. +5VDC and DC GND are the first two connection points from left to right in your photo. The last two are the AC (siginal).

Cheers!

Kal

[kal]

Hi Jason,

Wiring instructions are included on the page where you ordered. See: https://shop.theelectricbrewery.com/collections/power-supplies/products/3-digit-blue-led-digital-panel-volt-meter-700v-ac-5v-dc-supply

The "volt and amp meter wiring instructions" section of our control panel build instructions also goes into further detail: http://www.theelectricbrewery.com/control-panel-part-2?page=9

You've got the red and black wires connected to the AC (signal) inputs and no the +5VDC and DC GND. +5VDC and DC GND are the first two connection points from left to right in your photo. The last two are the AC (siginal).

Cheers!

Kal