|
|
|
|
|
View previous topic :: View next topic |
Author |
Message |
Feurhund
Joined: 01 Feb 2011 Posts: 89
|
Link Posted: Tue Feb 01, 2011 7:46 pm Post subject: BCS 460 automation |
|
|
Want to see if anyone set up their build to work with the BCS 460 system. For those that don't know it, it allows you to control all the plugged in elements, pumps, or anything through a computer interface, and even cooler it is web based, so I can control it wirelessly from my IPAD. This would essential replace the PIDs, but I am a complete layman on this stuff and learning so I wanted to see if anyone has made the modifications to use this unit. One thing I do know is that you have to use K type thermocouples instead of the ones Kal uses. I would also still like a manual switch for each element and pump with a master shut off, just for safety.
Just interested in if anyone has thought this out or done it.
Thanks all.
Feurhund.
|
|
Back to top |
|
|
crush
Joined: 28 Dec 2010 Posts: 706 Location: Telemark, Norway
|
Link Posted: Tue Feb 01, 2011 8:52 pm Post subject: |
|
|
I've thought about this, though I was going to go with the brewtroller board, which is a bit more hands-on. (IIRC, recently PT100 sensors are also supported.)
I like the simplicity, and stand-alone capability of Kal's setup, so I'm starting there, with just a few tweaks to allow back-to-back batches and using the timer/tachomoeter to measure/control my grainmill motor speed. Later, I will be building a brewtroller board to have on the side, initially, starting with just the bubbler volume level sensors since that adds immediate value without making any part of the control panel redundant.
Everyone's reasons are different. For me, automation isn't the goal in itself but one means of getting increased control, repeatability and accuracy during the brew. Even though not fully automated, Kal's setup delivers these goals in spades. With the BT board in place, being able to accurately measure the volume in the kettles and the gravity in the mash/boil kettle will help reach these goals also. (This might seem like lengths to go to just to get a volume and SG reading - I have difficulty reading the sight levels on the kettles and a refractometer, and I also like to play with toys! )
If it were possible to still use the PIDs together with an external board, that would be nice. I wonder if it's possible to connect a PT100 sensor to two devices?
_________________ ...just one more.
|
|
Back to top |
|
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum
|
Forum powered by phpBB © phpBB Group
|
|